Top 4 Tips About HPMC Solubility
December 18th 2024
If the hot soluble type (Non-surface treated) HPMC is added directly to the water, agglomeration will occur before dissolution. However, dissolving in this way is very slow and difficult. Here we recommend three dissolution methods for end users based on different applications：
1 Hot water dissolution method: Since HPMC is not dissolved in hot water, the initial HPMC can be uniformly dispersed in hot water and then rapidly dissolved upon cooling. Two typical methods as follows:
Adding hot water(85°C) into the container. Hydroxypropyl methylcellulose was gradually added with slow stirring, and the HPMC floated on the surface of the water, and then gradually formed a slurry, and the slurry was cooled with stirring.
Adding 1/3 or 2/3 of the required amount of hot water(85°C) to the vessel , gradually add HPMC to hot water and keep stirring. Cold water or ice water is then added to the hot cement slurry to achieve the desired level. Stirring is continued to cool the mixture.
2 Powder mixing method: Mix the HPMC powder with a large amount of other powdery substances, mix well with a blender, and then add water to dissolve. At this time, HPMC can be dissolved without agglomeration, because each tiny small corner has only a little HPMC. The powder will dissolve immediately upon contact with water. – This method is used by putty powder and mortar manufacturers.
3 Organic solvent humidification dissolution method: HPMC is pre-dispersed or wetted with an organic solvent such as ethanol, ethylene glycol or oil, and then dissolved in water, and HPMC can be easily dissolved.
Tags:
